Summers Superchisel - 5-Section Manuel d'utilisateur télécharger pdf (Page 53)

3-9

SECTION 3 – CHISEL PLOW OPERATION

6. Leveling the machine from front to back. Check depth of tillage at front and back of the machine.

If leveling is necessary, use wrenches provided to adjust the eyebolt on the front wheel assembly

up or down.

The front center lift arm has two cylinder attach locations. If chisel plow has a full set of mounted

harrows or if rear of machine is low in transport position, use rear cylinder attach hole. Connecting

front center cylinder to rear hole will lower front of chisel plow in transport position.

NOTE: It is best to check levelness of the chisel plow after each adjustment by working test

strips within the eld.

IMPORTANT!

Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on top

of the ground. Shut tractor off and relieve pressure by cycling remote lever back and forth.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 97 98

Pas de commentaire

Summers Superchisel - 5-Section Manuel d'utilisateur Page 53