Summers Superchisel - 5-Section Manuel d'utilisateur télécharger pdf (Page 52)

3-8

SECTION 3 – CHISEL PLOW OPERATION

5. Leveling the chisel plow from side to side. Stop the tractor with the machine still in the ground. Check

the depth of tillage on the left wing, center, and right wing. If leveling is necessary, use wrenches

provided to adjust the eyebolts on the cylinder attachments located at the rear of the machine.

*NOTE: Insure that cylinder attach holes are aligned when eyebolts are tightened.

One turn of the 1-1/2” NC Cylinder Attach Eye Bolt Nut changes chisel height 3/8”. One inch of ad-

justment moves chisel plow height over 2 inches. It may be necessary to move eyebolts a small

amount to attain correct adjustment of each section.

IMPORTANT!

Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on top

of the ground, shut tractor off and relieve pressure by cycling remote lever back and forth.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 97 98

Pas de commentaire

Summers Superchisel - 5-Section Manuel d'utilisateur Page 52