Summers Disk-Chisel Manuel d'utilisateur télécharger pdf (Page 26)

2-14

SECTION 2 – SET-UP OF 32’ AND 36’ WINGS

9. 36’ Only – Install wing extensions.

– One-shank extension must be placed on rear rank.

– Two-shank extension must be placed on front two ranks.

– Mounting bolts must point toward outside of machine. (Trip assembly interference will occur

if this is not followed.)

10. Install gauge wheel support (8T4090) onto wing with 7/8 x 2-1/2” bolts.

NOTE: Steps 10 through 15 may have been pre-assembled at factory.

11. Apply anti-seize to jack bolt (8T6000) threads. Screw jack bolt into axle holder (8T4094) far enough

to see hole on bottom of bolt through hole in axle holder.

– Insert 3/16 x 2” roll pin. Insert pin far enough so it will clear tube when rotated.

12. Place gauge wheel depth decal on axle holder.

– Locate decal 1” from bottom of 4 x 4 tube.

– Make sure that decal faces the front of the machine.

– Decal should be placed off to one side of axle holder to avoid seam on support tube.

13. Slide axle holder and jack bolt into gauge wheel support. Slide 1-1/4” ﬂ at washer onto bolt and

turn 1-1/4” slotted nut on.

– Do not tighten slotted nut.

14. Add gauge wheel screw top onto jack bolt.

– Insert 1/2 x 2-1/4” bolt into screw top and bolt, secure with locknut.

15. Attach gauge wheel jack handle to screw top.

– Install 3/8 x 2” bolt in handle and screw top. Secure with lock nut.

– Do not over tighten. Handle must pivot freely.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 118 119

Pas de commentaire

Summers Disk-Chisel Manuel d'utilisateur Page 26