Summers Disk-Chisel Manuel d'utilisateur télécharger pdf (Page 47)

DEPTH CONTROL HYD7/28/2010 9CC2412H.iam/

LEAVE ENOUGH

SLACK AT HITCH

PIVOT FOR FULL

RANGE OF TRAVEL

60" OF HOSE

(MIN)

LEAVE ENOUGH

SLACK FOR WING

TO PIVOT

SECTION 2 – HYDRAULIC SET-UP (24’ - 28’)

2-35

1. Hydraulic hoses and ttings for depth control cylinders can be found on following drawing.

– Rephasing cylinders require that oil from the rod end of rst cylinder goes to base end of

second cylinder and so forth. Cylinders will not operate properly unless they are connected

correctly.

2. Special attention should be paid to routing of hydraulic hoses. Diagram below shows layout of

hoses for depth control cylinders.

A. It is best to start by routing the hose for the 6 x 10” cylinder. Make sure there is 60” of hose

ahead of hose holder. This is usually enough hose for safe and easy hook-up to tractor.

B. Route hose along hitch frame. Use plastic clamps provided. Do not tighten until routing is

complete.

– Clamps are made to have the round surface point towards the surface that you are

mounting to. DO NOT OVER TIGHTEN.

C. Leave slack by hitch pivot.

1 2 ... 42 43 44 45 46 47 48 49

Pas de commentaire

Summers Disk-Chisel Manuel d'utilisateur Page 47